Hyundai Palisade: ISG (Idle Stop and Go) system / ISG System Malfunction
The ISG system may not operate:
When there is a malfunction with the
ISG sensors or the ISG system.
The followings occur, when there is
a malfunction with the ISG system:
- The auto stop indicator (
)
will
blink in yellow on the instrument
cluster.
- The light on the ISG OFF button
will illuminate.
Information
- When you cannot turn OFF the ISG
OFF button indicator by pressing the
ISG OFF button, or when the malfunction
with the ISG system persists,
contact an authorized
HYUNDAI dealer.
- You can turn off the ISG OFF button
indicator by driving over 50
mph (80 km/h) for up to 2 hours
with the fan speed below the 2nd
position. If the ISG OFF button
indicator remains ON, contact an
authorized HYUNDAI dealer.
WARNING
When the engine is in auto stop
mode, the engine may restart.
Before leaving the vehicle or
checking the engine compartment,
stop the engine placing
the ignition switch to the
LOCK/OFF position or remove
the ignition key.
Prerequisite for activation
The ISG system operates in the following
situations.
- The driver's seatbelt is fastened.
- The driver's door and the hood are
closed...
The battery sensor is deactivated,
when the battery is disconnected
from the negative pole for maintenance
purpose.
In this case, the ISG system is limitedly
operated due to the battery sensor
deactivation...
Other information:
Troubleshooting
Symptom
Possible cause
Remedy
Hard steering
Improper front wheel alignment
Correct
Excessive turning resistance of lower arm ball joint
Replace
Low tire pressure
Adjust
No power assist
Repair and replace
Poor return of steering wheel to center
Improper front wheel alignment
Correct
Poor or rough ride
Improper front wheel alignment
Correct
Malfunctioning shock absorber
Repair or replace
Broken or worn stabilizer
Replace
Broken or worn coil spring
Replace
Worn lower arm bushing
Replace the lower arm assembly
Abnormal tire wear
Improper front wheel alignment
Correct
Improper tire pressure
Adjust
Malfunctioning shock absorber
Replace
Wandering
Improper front wheel alignment
Correct
Poor turning resistance of lower arm ball joint
Repair
Loose or worn lower arm bushing
Retighten or replace
Vehicle pulls to one side
Improper front wheel alignment
Correct
Excessive turning resistance of lower arm ball joint
Replace
Broken or worn coil spring
Replace
Bent lower arm
Repair
Steering wheel shimmy
Improper front wheel alignment
Correct
Poor turning resistance of lower arm ball joint
Replace
Broken or worn stabilizer
Replace
Worn lower arm bushing
Replace
Malfunctioning shock absorber
Replace
Broken or worn coil spring
Replace
Bottoming
Broken or worn coil spring
Replace
Malfunctioning shock absorber
Replace
Wheel /tire noise, vibration and harshness concerns are directly related to
vehicle speed and are not generally affected by acceleration, coasting or decelerating...
The Vehicle Stability Management
(VSM) is a function of the Electronic
Stability Control (ESC) system. It
helps ensure the vehicle stays stable
when accelerating or braking suddenly
on wet, slippery and rough
roads where traction over the four
tires can suddenly become uneven...
Categories
The front seat can be adjusted by
using the levers located on the outside
of the seat cushion. Before driving,
adjust the seat to the proper
position so that you can easily control
the steering wheel, foot pedals
and controls on the instrument
panel.
![Hyundai Palisade. Manual adjustment](images/books/1/hyundai_palisade_manual_adjustment_7.png)
read more