Hyundai Palisade: Driving Your Vehicle / ISG (Idle Stop and Go) system
The Idle Stop and Go (ISG) system
automatically and temporarily shuts
down the engine when the vehicle is
stopped and idling to improve fuel
efficiency and reduce exhaust gas
emissions. (i.e. red stop light, stop
sign, and traffic jam).
The engine is automatically started
upon satisfying the starting conditions.
The ISG system is always active,
when the engine is running.
Information
When the engine is automatically
started by the ISG system, some warning
lights (i.e. ABS, ESC, ESC OFF,
EPS, and parking brake warning
light) may illuminate for a few seconds
due to the low battery voltage.
However, it does not indicate a malfunction
with the ISG system.
Tires
Do not use a tire and wheel package
with a different size and type from
the one originally installed on your
vehicle. It can affect the safety and
performance of your vehicle, which
could lead to steering failure or
rollover causing serious injury...
Prerequisite for activation
The ISG system operates in the following
situations.
- The driver's seatbelt is fastened.
- The driver's door and the hood are
closed...
Other information:
Applying the parking brake
To apply the EPB
(Electronic Parking Brake):
1. Depress the brake pedal.
2. Pull up the EPB switch.
Make sure the Parking Brake
i Warning Light comes on.
WARNING
To reduce the risk of SERIOUS
INJURY or DEATH, do not operate
the EPB while the vehicle is
moving except in an emergency
situation...
Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the luggage room lamp lens with a flat-tip screwdriver.
3.
Remove the luggage room lamp bulb...
Categories

If the remote key is not working properly,
try replacing the battery with a
new one.
Battery Type: CR2032
To replace the battery:
read more