Hyundai Palisade: What to Do in an Emergency / In Case of an Emergency While Driving
If the Engine Stalls While
Driving
- Reduce your speed gradually,
keeping a straight line. Move cautiously
off the road to a safe place.
- Turn on your hazard warning flasher.
- Try to start the engine again. If
your vehicle will not start, contact
an authorized HYUNDAI dealer or
seek other qualified assistance.
If the Engine Stalls at a
Crossroad or Crossing
If the engine stalls at a crossroads or
crossing, if safe to do so, move the
shift button to the N (Neutral) position
and then push the vehicle to a
safe location.
If you Have a Flat Tire While
Driving
If a tire goes flat while you are driving:
- Take your foot off the accelerator
pedal and let the vehicle slow down
while driving straight ahead. Do not
apply the brakes immediately or
attempt to pull off the road as this
may cause loss of vehicle control
resulting in an accident. When the
vehicle has slowed to such a speed
that it is safe to do so, brake carefully
and pull off the road. Drive off
the road as far as possible and
park on firm, level ground. If you
are on a divided highway, do not
park in the median area between
the two traffic lanes.
- When the vehicle is stopped, press
the hazard warning flasher button,
move the shift button into P (Park),
and apply the parking brake, and
place the ignition switch in the OFF
position.
- Have all passengers get out of the
vehicle. Be sure they all get out on
the side of the vehicle that is away
from traffic.
- When changing a flat tire, follow
the instructions provided later in
this chapter.
The hazard warning flasher serves
as a warning to other drivers to exercise
extreme caution when approaching,
overtaking, or passing your vehicle.
It should be used whenever emergency
repairs are being made or
when the vehicle is stopped near the
edge of a roadway...
If the Engine Doesn't Turn
Over or Turns Over Slowly
Be sure the shift button is in N
(Neutral) or P (Park). The engine
starts only when the shift button is
in N (Neutral) or P (Park)...
Other information:
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the cluster fascia panel (A).
(Refer to Body - "Cluster Fascia Panel")
3.
Remove the cluster (A) from the housing after removing screws...
Components and components location
Component Location
1. Rear door latch
Repair procedures
Replacement
•
Put on gloves to prevent hand injuries...
Categories
Seat belt warning light
Driver's seat belt warning
As a reminder to the driver, the seat
belt warning light will illuminate for
approximately 6 seconds each time
you place the ignition switch to the
ON position regardless of belt fastening.
At this time, if the seat belt is
not fastened a warning chime will
sound for 6 seconds.
read more