Hyundai Palisade (LX2): Ignition System / Description and operation

Hyundai Palisade (LX2) 2020-2026 Service Manual / Engine Electrical System / Ignition System / Description and operation

Description
Ignition timing is controlled by the electronic control ignition timing system.
The standard reference ignition timing data for the engine operating conditions are pre-programmed in the memory of the ECM (Engine Control Module).
The engine operating conditions (speed, load, warm-up condition, etc.) are detected by the various sensors. Based on these sensor signals and the ignition timing data, signals to interrupt the primary current are sent to the ECM.
The ignition coil is activated, and timing is controlled.

    On-vehicle Inspection Inspect ignition coil assembly and Perform spark test 1. Check for DTCs.    • If a DTC is present, perform troubleshooting in accordance with the procedure for that DTC.

    Other information:

    Hyundai Palisade (LX2) 2020-2026 Service Manual: Compressor

    Description and operation Description The compressor is the power unit of the A/C system. It is located on the side of engine block and driven by a V-belt of the engine. The compressor changes low pressure and low temperature refrigerant gas into high pressure and high temperature refrigerant gas.

    Hyundai Palisade (LX2) 2020-2026 Service Manual: Repair procedures

    Inspection 1. Turn the ignition switch ON. 2. Manually operate the control switch and measure the voltage of the blower motor. 3. Select the control switch to raise the voltage until it reaches high speed.

    Categories

     
    Copyright © 2026 www.hpalisadelx.com - 0.0116