Hyundai Palisade: Tires and wheels / Check Tire Inflation Pressure

Hyundai Palisade (LX2) 2020-2024 Owner's Manual / Maintenance / Tires and wheels / Check Tire Inflation Pressure

Check your tires, including the spare tire, once a month or more.

How to check

Use a good quality tire pressure gauge to check tire pressure. You can not tell if your tires are properly inflated simply by looking at them. Radial tires may look properly inflated when they are under-inflated.

Remove the valve cap from the tire valve stem. Press the tire gauge firmly onto the valve to get a pressure measurement. If the cold tire inflation pressure matches the recommended pressure on the tire label located on the driver's side center pillar or in this manual. No further adjustment is necessary. If the pressure is low, add air until you reach the recommended pressure. Make sure to put the valve caps back on the valve stems. Without the valve cap, dirt or moisture could get into the valve core and cause air leakage. If a valve cap is missing, install a new one as soon as possible.

If you overfill the tire, release air by pushing on the metal stem in the center of the tire valve. Recheck the tire pressure with the tire gauge. Be sure to put the valve caps back on the valve stems. Without the valve cap, dirt or moisture could get into the valve core and cause air leakage. If a valve cap is missing, install a new one as soon as possible.

A cold tire means the vehicle has been sitting for 3 hours and driven for less than 1 mile (1.6 km) in that 3 hour period.

Allow the tire to cool before measuring the inflation pressure. Always be sure the tire is cold before inflating to the recommended pressure.

Recommended Cold Tire Inflation Pressures

All tire pressures (including the spare) should be checked when the tires are cold. "Cold tires" means the vehicle has not been driven for at least three hours or has been driven for less than one mile (1...

Tire Rotation

To equalize tread wear, HYUNDAI recommends that the tires be rotated according to the maintenance schedule or sooner if irregular wear develops. During rotation, check the tires for correct balance...

Other information:

Hyundai Palisade (LX2) 2020-2024 Service Manual: Heater & A/C Control Unit (Rear)

Components and components location Component Connector Pin Function Connector PIN No Pin Function Connector PIN No Pin Function A 1 Battery A 17 IGN2 2 ISG B+ 18 IGN1 3 ILL+ (TAIL) 19 Blower Motor (+) 4 Sensor Ground REF (+5V) 20 - 5 Mode Control Actuator Feedback 21 Mosfet (DRAIN F/B) 6 Temperature Actuator Feedback 22 Mosfet (GATE) 7 Mode Control Actuator (Vent) 23 Heater Switch _ LH 8 Mode Control Actuator (Defrost) 24 Indicator (HIGH) _ LH 9 Temperature Control Actuator (Cool) 25 Indicator (MID) _ LH 10 Temperature Control Actuator (Warm) 26 Indicator (LOW) _ LH 11 Detent out (-) 27 Heater Switch _ RH 12 K - Line 28 Indicator (HIGH) _ RH 13 LIN Left 29 Indicator (MID) _ RH 14 Lin Right 30 Indicator (LOW) _ RH 15 - 31 Sensor Ground 16 ILL - (RHEO) 32 Ground Repair procedures Replacement • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components...

Hyundai Palisade (LX2) 2020-2024 Owner's Manual: Rear climate control

■ 2nd row air conditioning control 1. AUTO button 2. Temperature control button 3. Mode selection button 4. Fan speed control button 5. OFF button 6. Climate control information screen If you press the rear climate control button of the front climate control system, rear passengers can control the rear climate system by using the rear climate control system...