Hyundai Palisade: Towing / Removable Towing Hook

1. Open the liftgate, and remove the
towing hook from the tool case.

■ Front

■ Rear
2. Remove the hole cover by pressing
the lower part of the cover on
the front or rear bumper.
3. Install the towing hook by turning it
clockwise into the hole until it is
fully secured.
4. Remove the towing hook and
install the cover after use.
[A] : Dollies
If emergency towing is necessary,
we recommend having it done by an
authorized HYUNDAI dealer or a
commercial tow-truck service.
Proper lifting and towing procedures
are necessary to prevent damage to
the vehicle...
If towing is necessary, we recommend
you have it done by an authorized
HYUNDAI dealer or a commercial
tow truck service.
If towing service is not available in an
emergency, your vehicle may be
temporarily towed using a cable or
chain secured to the emergency towing
hook at the front (or rear) of the
vehicle...
Other information:
The Surround View Monitoring system
can assist in parking by allowing
the driver to see around the vehicle.
Push the button (1, indicator ON) to
operate the system. To cancel the
system, push the button again (1,
indicator OFF).
The system is activated when:
The engine is ON
The shift button is in D (Drive), N
(Neutral) or R (Reverse)
Vehicle speed is under 10 mph (15
km/h)
The system is deactivated when:
You press the button (1) again
Vehicle speed is over 10 mph (15
km/h)
Information
When vehicle speed is over 10 mph
(15 km/h), the system will turn off...
Repair procedures
Removal
1.
Remove the fuel pump.
(Refer to Fuel Delivery System - "Fuel Pump")
2.
Disconnect the fuel sender connector (A).
3.
Remove the fuel sender (A) in the direction of an arrow...
Categories

If the remote key is not working properly,
try replacing the battery with a
new one.
Battery Type: CR2032
To replace the battery:
read more