Hyundai Palisade (LX2): Rear Mode Control Actuato / Repair procedures
| Replacement |
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the luggage side trim
(Refer to Body - "Luggage Side Trim ")
|
| 3. |
Separate the rear mode actuator connector (A), loosen the mounting screws
and remove the rear mode actuator (B).
|
| 4. |
Install in the reverse order of removal.
|
Other information:
Hyundai Palisade (LX2) 2020-2026 Service Manual: Compressor
Description and operation Description The compressor is the power unit of the A/C system. It is located on the side of engine block and driven by a V-belt of the engine. The compressor changes low pressure and low temperature refrigerant gas into high pressure and high temperature refrigerant gas.
Hyundai Palisade (LX2) 2020-2026 Service Manual: Auto Defogging Sensor
Description and operation Description The auto defogging sensor is installed on the front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging. The air conditioner control module receives signal from the sensor and restrains moisture and eliminate defog by controlling the intak
Categories
- Manuals Home
- Hyundai Palisade Owners Manual
- Hyundai Palisade Service Manual
- Rear Heater Unit
- Electronic Child Safety Lock System
- Body Electrical System
- New on site
- Most important about car
Copyright © 2026 www.hpalisadelx.com - 0.0143