Hyundai Palisade: Wipers and washers / Front Windshield Washers

In the OFF position, pull the lever
gently toward you to spray washer
fluid on the windshield and to run the
wipers 1-3 cycles. The spray and
wiper operation will continue until
you release the lever. If the washer
does not work, you may need to add
washer fluid to the washer fluid
reservoir.
WARNING
When the outside temperature
is below freezing, ALWAYS
warm the windshield using the
defroster to help prevent the
washer fluid from freezing on
the windshield and obscuring
your vision which could result
in an accident and serious
injury or death.
NOTICE
- To prevent possible damage to
the washer pump, do not operate
the washer when the fluid
reservoir is empty.
- To prevent possible damage to
the wipers or windshield, do not
operate the wipers when the
windshield is dry.
- To prevent damage to the wiper
arms and other components, do
not attempt to move the wipers
manually.
- To prevent possible damage to
the wipers and washer system,
use anti-freezing washer fluids
in the winter season or cold
weather.
Operates as follows when the ignition
switch is in the ON position.
MIST : For a single wiping cycle,
push the lever upward and
release. The wipers will operate
continuously if the lever is
held in this position...
The rear window wiper and washer
switch is located at the end of the
wiper and washer switch lever. Turn
the switch to the desired position to
operate the rear wiper and washer...
Other information:
Components and components location
Component Location
1. Luggage side trim
Repair procedures
Replacement
•
When removing with a flat-tip screwdriver or remover, wrap protective
tape around the tools to prevent damage to components...
The Hill-Start Assist Control (HAC)
helps prevent the vehicle from rolling
backwards when starting a vehicle
from a stop on a hill. The system
operates the brakes automatically for
approximately 2 seconds and releases
the brake after 2 seconds or when
the accelerator pedal is depressed...
Categories
Rear seat adjustment

Forward and rearward
(2nd row seat)
To move the seat forward or rearward:
1. Pull the seat slide adjustment
lever up and hold it.
2. Slide the seat to the position you
desire.
read more