Hyundai Palisade (LX2): Engine And Transaxle Assembly / Engine Cover

Hyundai Palisade (LX2) 2020-2026 Service Manual / Engine Mechanical System / Engine And Transaxle Assembly / Engine Cover

Repair procedures

Removal and Installation
1.
Remove the engine cover (A).

Hyundai Palisade. Repair procedures

Hyundai Palisade. Repair procedures   
•
Lift up the lower end of engine cover, then left and right alternately.
•
When installing, confirm that the mounting rubber insulators has been installed.
2.
Install in the reverse order of removal.

    Repair procedures Removal and Installation    • Be careful not to damage the parts located under the vehicle (floor under cover, fuel filter, fuel tank and canister) when raising the vehicle using the lift.

    Other information:

    Hyundai Palisade (LX2) 2020-2026 Service Manual: Repair procedures

    Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the luggage side trim (Refer to Body - "Luggage Side Trim ") 3. Separate the rear mode actuator connector (A), loosen the mounting screws and remove the rear mode ac

    Hyundai Palisade (LX2) 2020-2026 Service Manual: Rear Corner Safety ON/OFF Switch

    Components and components location Circuit Diagram Repair procedures Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crashpad Lower Panel") 3.

    Categories

     
    Copyright © 2026 www.hpalisadelx.com - 0.02