Hyundai Palisade (LX2): Cylinder Block / Drive Plate

Hyundai Palisade (LX2) 2020-2026 Service Manual / Engine Mechanical System / Cylinder Block / Drive Plate

Repair procedures

Removal and Installation
Hyundai Palisade. Repair procedures   
•
Be careful not to damage the parts located under the vehicle (floor under cover, fuel filter, fuel tank and canister) when raising the vehicle using the lift.
(Refer to General Information - "Lift and Support Points")
1.
Remove the automatic transaxle.
(Refer to Automatic Transaxle System - "Automatic Transaxle")
2.
Remove the adapter plate (B) and the drive plate (A).
Tightening torque :
71.6 - 75.5 N.m (7.3 - 7.7 kgf.m, 52.8 - 55.7 lb.ft)

Hyundai Palisade. Repair procedures
3.
Install in the reverse order of removal.

    Repair procedures Removal    • Be careful not to damage the parts located under the vehicle (floor under cover, fuel filter, fuel tank and canister) when raising the vehicle using the lift.

    Repair procedures Replacement    • Be careful not to damage the parts located under the vehicle (floor under cover, fuel filter, fuel tank and canister) when raising the vehicle using the lift.

    Other information:

    Hyundai Palisade (LX2) 2020-2026 Service Manual: Repair procedures

    Inspection 1. Turn the ignition switch ON. 2. Manually operate the control switch and measure the voltage of the blower motor. 3. Select the control switch to raise the voltage until it reaches high speed.

    Hyundai Palisade (LX2) 2020-2026 Service Manual: Description and operation

    Description Rear view camera will activate when the backup light is ON with the ignition switch ON and the shift lever in the R position. This system is a supplemental system that shows behind the vehicle through the AV monitor or the ECM (Reverse Display Room Mirror) mirror while backing-up.

    Categories

     
    Copyright © 2026 www.hpalisadelx.com - 0.0126