Hyundai Palisade: Power Liftgate / Power liftgate opening height user setting

Hyundai Palisade (LX2) 2020-2024 Owner's Manual / Convenient Features of Your Vehicle / Exterior features / Power Liftgate / Power liftgate opening height user setting

Hyundai Palisade. user setting

Follow the instructions below to set the fully open height of the power liftgate:

1. Position the liftgate manually to the height you prefer.

2. Press the power liftgate inner button for more than 3 seconds.

3. Close the liftgate manually after hearing the buzzer sound.

The liftgate will open to the manually adjusted height that was set.

WARNING

Always keep the liftgate completely closed while the vehicle is in motion. If it is left open or ajar, poisonous exhaust gases containing carbon monoxide (CO) may enter the vehicle and serious illness or death may result.

WARNING

Rear cargo area

Occupants should never ride in the rear cargo area where no restraints are available.To avoid injury in the event of an accident or sudden stops, occupants should always be properly restrained.

    How to reset the power liftgate

    If the battery has been discharged or disconnected, or if the power liftgate fuse has been replaced or removed, reset the power liftgate by performing the following procedure: 1...

    Emergency liftgate safety release

    Your vehicle is equipped with an emergency liftgate safety release lever located on the bottom of the liftgate inside the vehicle. To unlock and open the liftgate manually from inside the luggage compartment, perform the following steps: 1...

    Other information:

    Hyundai Palisade (LX2) 2020-2024 Service Manual: Repair procedures


    Replacement    • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components...

    Hyundai Palisade (LX2) 2020-2024 Service Manual: Crankshaft Position Sensor (CKPS)


    Description and operation Description Crankshaft Position Sensor (CKPS) detects the crankshaft position and is one of the most important sensors of the engine control system. Lack of CKPS signal may cause the engine to stop. Installed on the cylinder block or the transaxle housing, it generates alternating current by magnetic flux field made from the sensor and the target wheel during engine runnig...

    Categories

    How Does the Air Bag System Operate?

    Hyundai Palisade. Operate?

    The SRS consists of the following components:

    1. Driver's front air bag module
    2. Passenger's front air bag module
    3. Side air bag modules
    4. Curtain air bag modules
    5. Retractor pre-tensioner
    6. Air bag warning light
    7. SRS control module (SRSCM)/ Rollover sensor
    8. Front impact sensors
    9. Side impact sensors
    10.Side pressure sensors
    11. Occupant classification system
    12. Driver’s knee airbag module

    read more


     
    Copyright © 2024 www.hpalisadelx.com