Hyundai Palisade: Driving Your Vehicle / Leading Vehicle Departure Alert

Hyundai Palisade (LX2) 2020-2024 Owner's Manual / Driving Your Vehicle / Leading Vehicle Departure Alert

The Leading Vehicle Departure Alert system alerts the driver of the departure of the vehicle in front when the vehicle is stopped and the Smart Cruise Control (SCC) system is operating.

System Setting and Operation

System setting

The Leading Vehicle Departure Alert can be activated from the User Settings menu in the cluster LCD display by following the procedure below.

1. Set the ignition switch to the ON position.

2. Select 'User Settings → Driver Assistance → Leading Vehicle Departure Alert' in the cluster LCD display.

The system stops operation when the setting is deactivated. However, if the engine is turned off then on again, the system maintains the previous state.

System standby

Hyundai Palisade. Leading Vehicle Departure Alert

Use switch or pedal to accelerate

While the Smart Cruise Control (SCC) system is operating, your vehicle stops behind the vehicle in front when it stops. The message shown above is displayed on the cluster within 3 seconds after the stop and the system will be in the standby position.

System operation

Hyundai Palisade. Leading Vehicle Departure Alert

Leading vehicle is driving away

If the driver does not take action for a certain period of time after the vehicle in front departs, the message shown above is displayed on the cluster.

The vehicle departs automatically if the accelerator pedal is depressed or RES + or SET - toggle switch is pushed up or down when there is a vehicle in front.

The Smart Cruise Control (SCC) system is deactivated if the accelerator pedal is depressed or RES + or SET - toggle switch is pushed up or down when there is no vehicle in front.

WARNING

Always check the front of the vehicle and road conditions before departure.

    Limitations of the System

    The Smart Cruise Control system may have limits to its ability to detect distance to the vehicle ahead due to road and traffic conditions. On curves The Smart Cruise Control system may not detect a moving vehicle in your lane, and then your vehicle could accelerate to the set speed...

    Special Driving Conditions

    Hazardous Driving Conditions When hazardous driving elements are encountered such as water, snow, ice, mud and sand, take the below suggestions: Drive cautiously and keep a longer braking distance...

    Other information:

    Hyundai Palisade (LX2) 2020-2024 Service Manual: Manifold Absolute Pressure Sensor (MAPS)


    Description and operation Description Manifold Absolute Pressure Sensor (MAPS) is a speed-density type sensor installed on the surge tank. It senses absolute pressure of the surge tank and transfers the analog signal proportional to the pressure to the ECM...

    Hyundai Palisade (LX2) 2020-2024 Service Manual: Rear Hub - Carrier


    Components and components location Components 1. Rear brake disc 2. Rear hub assembly 3. Dust cover 4. Rear carrier assembly Repair procedures Removal 1. Loosen the wheel nuts slightly...

    Categories

    Manual adjustment

    The front seat can be adjusted by using the levers located on the outside of the seat cushion. Before driving, adjust the seat to the proper position so that you can easily control the steering wheel, foot pedals and controls on the instrument panel.

    Hyundai Palisade. Manual adjustment

    read more


     
    Copyright © 2024 www.hpalisadelx.com