Hyundai Palisade: Blower / Climate Control Air Filter

Hyundai Palisade (LX2) 2020-2025 Service Manual / Heating,Ventilation And Air Conditioning / Blower / Climate Control Air Filter

Description and operation

Description

The climate control air filter is located in the blower unit. It eliminates foreign materials and odor. The particle filter performs a role as an odor filter as well as a conventional dust filter to ensure comfortable interior environment.

Repair procedures

Replacement

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•	Put on gloves to prevent hand injuries.

1.	Remove the stopper (B) from the glove box (A).

2.	Remove the air damper (A) from the glove box (B).

3.	Remove the filter cover (A) by pressing the knob.

4.	Replace the air filter (A) with a new one according to the direction of air filter.

Install in the reverse order of removal.

•	To remove the filter easily, press the right side inward then pull out the filter.

•	In case of driving in an air-polluted area or rugged terrain, check and replace the air filter as frequently as possible.

Power Mosfet (DATC)

Repair procedures Inspection 1. Turn the ignition switch ON. 2. Manually operate the control switch and measure the voltage of the blower motor...

Intake Actuator

Description and operation Description The intake actuator is located at the blower unit. It regulates the intake door by a signal from the control unit...

Other information:

Hyundai Palisade (LX2) 2020-2025 Owner's Manual: Sunroof

If your vehicle is equipped with a sunroof, you can slide or tilt your sunroof with the sunroof control lever located on the overhead console. The ignition switch must be in the ON position before you can open or close the sunroof. The sunroof can be operated for approximately 10 minutes after the ignition switch is removed or turned to the ACC or LOCK/OFF position...

Hyundai Palisade (LX2) 2020-2025 Owner's Manual: LCD display message

Shifting conditions not met The warning message appears on the LCD display, when engine RPM is too high, or when driving speed is too fast to shift the gear. We recommend you decrease the engine speed or slow down before shifting the gear. Press brake pedal to change gear The warning message appears on the LCD display, when the brake pedal is not depressed while shifting the gear...